Presentation of the ALLMATIC PRO433 antenna This antenna is tuned to a frequency of 433 MHz and will therefore be fully compatible with ALLMATIC motors operating at the same frequency. A radio antenna is very useful for your motorization systems: it will allow you to considerably increase the range of the signal. Indeed, the radio signal emitted by your transmitter to your receiver may be jammed, either because of too long a distance, or because of obstacles obstructing the signal (trees, rocks or buildings). Thanks to the ALLMATIC PRO433 antenna, you will be able to considerably increase the action distance, to be able to control your automations even further than before. Installation and fixing The ALLMATIC PRO433 antenna can be fixed directly on a wall, preferably flat, using a 2 meter long cable. This 2 meter cable will significantly increase the signal range. The cable will connect the antenna to your receiver so that it can function properly. To attach your antenna to your wall, simply use the screws provided with your antenna: be careful when installing your ALLMATIC PRO433 antenna, be careful not to install it too close to another antenna or any other source of interference, such as a laptop computer. In principle, radio antennas are fixed outdoors, so that they are as close as possible to the receiver. The cable has been designed for outdoor installation since it is made of stainless steel: therefore, it is very resistant to water and humidity. However, be sure to place your antenna as sheltered as possible, to prevent it from being too damaged by extreme weather conditions. We advise our customers to install the antennas as high as possible, so that the signal and range are optimized as much as possible. The ALLMATIC PRO433 antenna: a guarantee of practicality Signal drops are very common among beneficiaries of motorization systems of all kinds. To overcome this problem, radio antennas are ideal. They will be able to optimize the radio signal allowing you to open and close your gate in no time. Indeed, if you notice a problem or delay when you press your remote, it could be a radio signal problem. In addition, the radio antenna will allow you to control your automations even further: it can increase your range from 30 to 50 meters. The radio antenna represents a suitable solution for large plots and gardens. So, if you notice difficulty controlling your automations from your car or your garden, you can optimize the control distance of your Allmatic automations using the ALLMATIC PRO433 antenna. Compatibilities The advantage with the ALLMATIC PRO433 antenna is that it will be compatible with most transmitters and receivers in the Allmatic range operating at 433 MHz. So, if you have the Allmatic ASR2B 433/AP LED receiver, you can easily connect the ALLMATIC PRO433 radio antenna to it. It will thus optimize the reception quality of the radio signal from your Allmatic motors. For the remote controls, the same thing: they will have to operate at a frequency of 433 MHz. For example, it can be installed if you have ALLMATIC MASTER-D or ALLMATIC ARMY2 remote controls. Order your ALLMATIC PRO433 radio antenna now on Allo Remotecontrol The installation instructions for the ALLMATIC PRO433 radio antenna are not available in PDF; however, we will provide it to you with your product when you purchase it. The installation instructions will allow you to correctly install, fix and use your antenna. If you wish to add a remote control to your basket, please note that for the purchase of 2 or more remote controls, you can benefit from free delivery. Consider ordering remote controls compatible with your motorization system. Please also note that the warranty for your product may extend to two additional years: do not hesitate to consult our General Terms and Conditions for more information.