Presentation of the ALLMATIC B.RO You can program all Rolling Code transmitters in the ALLMATIC range on this receiver. The operation of this receiver is simple and intuitive: the display interface and its 3 keys will greatly facilitate its use. This interface will allow you to know the operating status of your receiver and any errors (memory not found, incorrect coding, lower power supply voltage, etc.). Thanks to this, you can protect the data on your receiver using a password. The 4 relays can operate using 4 different modes: “Dead man” mode (immediate) “Step by step” mode “Timed” mode “Timed with delay” mode The relay outputs can be connected to a wired input or to a single button on a memorized remote control. Regarding learning the keys of your transmitter, you can do it using three procedures: Default/customizable learning Sequential learning Advanced learning ALLMATIC B.RO X40 DISPLAY receiver interface This interface is presented in the form of a small rectangular screen: it will allow you to be kept informed of everything that is happening in your receiver. During the various procedures (programming, storage, installation), this interface will display codes to indicate the status of the procedure. It is possible to protect this interface using a password: to change your password for the first time, press the UP ( ) and DOWN (-) keys then briefly press the MENU key to switch to to the successive digit. This interface will offer you the possibility of deactivating all learning on your receiver: you will not need a password for this procedure. It is also possible to delete all transmitters previously registered in your receiver. The interface is not the only signaling you will benefit from with this receiver: the LEDs will also be there to guide you on the status of the outputs, thanks to the OUT1, OUT2, OUT3 and OUT4 LEDs. Default learning This learning mode will allow you to memorize the keys of one of your transmitters with a simple click on one of the buttons. If the transmitter is already memorized in your receiver, learning will restore the transmitter to default values. After 10 seconds of inactivity, your control unit will automatically exit learning mode. It is possible to delete all transmitters registered in your ALLMATIC B.RO X40 DISPLAY receiver. This deletion does not concern the parameters of your receiver, but only those of your transmitters. To do this, move to the voice “trf” in the menu, then confirm by clicking the “MENU” button. Hold this key until your screen displays “O”, then release the button. Again, press and hold the “MENU” key. After the countdown, your transmitters will have been successfully deleted if the display shows “Fdon”. Compatibility of ALLMATIC B.RO your automations at a range of 80 to 250m. It will operate at a frequency of 433.92 MHz. Its case has dimensions of around 125 x 55 x 44mm. You can use this receiver at temperatures ranging from -10°C to 55°C. If you choose this ALLMATIC brand receiver, please note that on Allo Remotecontrol.com, your warranty can be extended to two additional years, one of which is completely free. For more information, do not hesitate to visit our T&Cs, or to contact our customer service.