Introducing the ALLMATIC B.RO MINI 1CH Receiver This receiver is a design by ALLMATIC, a home automation company that combines a team of professional innovators with high-quality materials. ALLMATIC products are all, without exception, certified to current European standards and directives. It is a variable code receiver. ALLMATIC has designed this product to make your daily life easier: you will benefit from easy and intuitive programming as well as disconcerting flexibility in learning and handling the buttons of compatible remote controls. This system has a cable with a length of 30cm. The LED indicator, located on its case, will allow you to indicate whether the radio signal is operational or not. Its technical characteristics This transmitter is equipped with a 12-24Vac/dc power supply and can memorize up to 1000 transmitters. Its transmission range may vary between 80 and 250m depending on the type of transmitter, antenna and radio interference. Radio interference is caused either by two receivers in close proximity or by sources of harmful interference such as a laptop, magnets, etc. To prevent interference from excessively jamming your radio signal, try plugging in your antenna as far as possible from significant sources of interference. You will be able to operate this receiver in temperatures between -10°C and 55°C. Program a new transmitter To program a new transmitter on the ALLMATIC B.RO MINI 1CH receiver, nothing could be simpler. To do this, follow the instructions below: 1st step: Select the supply voltage using the jumper to power your receiver 2nd step: Then press the programming/learning button on your receiver: the LED should start flashing 3rd step: Press any button on your transmitter (the one you wish to link to the control of your automation): the LED should flash in 2 steps to signal successful memorization 4th step: Your receiver has recorded successfully your new transmitter. It is therefore ready to be used and to operate your automations 5th step: If you wish to memorize other transmitters, simply repeat this procedure. Your receiver records a unique key for each of your transmitters: if you wish to memorize a second key, this will replace the previous one Relay operating modes The relay operating modes of the ALLMATIC B.RO MINI 1CH receiver are double: you can make it operate “IMMEDIATELY”, that is to say that the relay will be active as long as the radio signal is effective, which means that the relay output is closed as long as the remote control button is kept pressed. You can operate the relay in “TIMED” mode, which consists of leaving the relay active for a defined time between 1 and 60 seconds. You can therefore choose the operating mode you want by following the following procedure: 1st step: Press and hold the programming button for approximately 10 seconds (wait for the LED to flash) 2nd step: Once the LED flashes quickly, release the button (immediate operation) 3rd step: Press and release the programming button to increase the relay activation time. The LED will flash with each pulse. 4th step: Hold down the programming button for more than 5 seconds 5th step: When the LED flashes, you can release the button: the time has been recorded Compatibility of the ALLMATIC B.RO MINI 1CH receiver This receiver is compatible with: all ALLMATIC variable code remote controls, in 433.92 MHz including the ALLMATIC BRO STAR remote control, which operates at a frequency of 433.92 Mhz Product Warranty The product warranty will only cover defective parts that are the result of low quality or faulty materials and internal malfunctions, but will not cover malfunctions due to poor maintenance, or a poor quality battery. If you wish, it is possible to extend your warranty free of charge to an additional year, or even two years. For more information on our guarantees, do not hesitate to take a look at our General Terms and Conditions.